Structure Cylinders

These cylinders are designed for texturing hard foam. The cylinders are made out of a hard shock proof plastic. The structure in each cylinder is deep and the lines are sharp in order to get a perfect result even with less pressure.

To get a good imprint a round stick is used. By rolling the cylinder using the stick you apply only pressure where pressure is needed; The area where the cylinder touches the foam. Using two discs on either side of the cylinder help you to align the cylinder while rolling it over the foam.

At the start of 2021 a new series of cylinders is added to the existing Basic Cylinder series. The Tiny Cylinder series. A smaller/finer version of the basic Cylinder Series.

Basic Cylinder series

This Cylinder series is designed for the 28-32 mm miniature range. Depending on the texture some of these structures also fit well within the 20 mm range.

Tiny Cylinder series

The Tiny Cylinder series is a range of cylinders that are developed for 20 mm / H0 scale. Depending on the texture some of these structures also fit well within the 28 mm range